Double Solenoid Inlet Valve
R290,00
Check your model number below. Still unsure? Send us a photo of your appliance label.
About this part
Universal Front Loader Washing Machine Double Water Inlet Valve – 220V
The Universal Front Loader Washing Machine Double Water Inlet Valve is a replacement dual-solenoid valve suitable for selected front loader washing machines that use a matching 220V water inlet system. The valve controls the flow of water entering the appliance during the filling, washing and rinsing stages of the programme.
Each solenoid controls a separate internal water channel, allowing the washing machine to direct water through the required dispenser compartment. A faulty inlet valve may prevent the machine from filling, cause slow or uneven filling, stop water from reaching a dispenser section or allow water to enter the drum while the appliance is switched off.
Product Features
- Part type: Front loader washing machine double water inlet valve
- Operating voltage: 220V AC
- Outlet diameter: Approximately 10.5mm
- Valve configuration: Two electrically operated solenoids
- Outlet configuration: Straight dual outlets
- Suitable for selected front loader washing machines
- Controls water entering the appliance during filling and rinsing
- Directs water through the required detergent-dispenser channels
- Normally closed water-control valve
- Suitable as a replacement where the voltage, dimensions and connections match
- Replacement for leaking, blocked, damaged or non-working inlet valves
Common Symptoms This Part May Fix
- Front loader washing machine not filling with water
- Machine filling very slowly
- Only one inlet-valve channel operating
- Water not flowing through the required dispenser compartment
- Detergent or fabric softener remaining in the dispenser drawer
- Buzzing from the valve without water entering
- Water continuing to enter after the machine is switched off
- Water slowly leaking into the drum between wash cycles
- Washing machine stopping while waiting to fill
- Water-supply or filling error appearing
- Water leaking from the valve body or hose connections
Important Fitment Note
This is a universal replacement valve intended for selected front loader washing machines only. Before ordering, compare the 220V coil rating, two-solenoid configuration, approximately 10.5mm straight outlets, threaded water inlet, electrical terminals, mounting bracket, hose directions and overall dimensions with the original valve.
Turn off the water supply and disconnect the washing machine from the electrical supply before removing or installing the inlet valve.
Check your model
R290,00